LevelOne GES-1651 - Manual (Page 19)

13
Figure 4-6 Daylight Saving Time
The following entries are displayed on this screen:
 DST Config
DST Status: Enable or disable the DST.
Predefined Mode: Select a predefined DST configuration.
 USA: First Sunday in April, 02:00 ~ Last Sunday in October,
02:00.
 Australia: First Sunday in October, 02:00 ~ First Sunday in
April, 03:00.
 Europe: Last Sunday in March, 01:00 ~ Last Sunday in
October, 01:00.
 New Zealand: First Sunday in October, 02:00 ~ Last Sunday in
March, 03:00.
Recurring Mode: Specify the DST configuration in recurring mode. This
configuration is recurring in use.
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of Daylight
Saving Time.
Date Mode: Specify the DST configuration in Date mode. This configuration is
one-off in use.
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of Daylight
Saving Time.
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of Europe in predefined mode.