LevelOne GES-1652 - Manual (Page 44)

Web Smart Switch
44
The following table describes the labels in this screen.
LABEL DESCRIPTION
Port Select the ports to enable bandwidth control on.
Type Select the type of traffic to control, Ingress (incoming) or Egress
(outgoing).
State Select Enable to activate bandwidth control on the selected ports.
Select Disable to turn off bandwidth control on the selected ports.
Rate (Kbit/sec) Configure the desired bandwidth available to the port’s traffic flow. Traffic
that exceeds the maximum bandwidth allocated (in cases where the
network is congested) is dropped. Specify the bandwidth in kilobit per
second (Kbps). Enter a number between 0 and 1048544. The number must
be a multiple of 16.
Apply Click Apply to save your changes to the switch.
Port This field displays the port number.
Ingress Rate
(Kbit/sec) This field displays the maximum bandwidth allowed for incoming traffic on
the port in kilobits per second (Kbps). The default setting is Unlimited.
Egress Rate
(Kbit/sec) This field displays the maximum bandwidth allowed for outgoing traffic on
the port in kilobits per second (Kbps). The default setting is Unlimited.