LevelOne WAB-6120 - Manual (Page 24)

Chapter 3 Basic Settings Page 14
Chapter 3 Basic Settings
Factory Default Settings
We’ll elaborate the LEVELONE 150MBPS WIRELESS POE AP factory default settings. You can
re-acquire these parameters by default. If necessary, please refer to the “ Restore Factory Default
Settings ”.
Table 1 LEVELONE 150MBPS WIRELESS POE AP Factory Default Settings
Features Factory Default Settings
Username admin
Password admin
Wireless Device Name apXXXXXX (X represents the last 6
digits of Ethernet MAC address)
Operating Mode AP
Data Rate Auto
LAN
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Gateway 0.0.0.0
Primary DNS Server 0.0.0.0
Secondary DNS Server 0.0.0.0
Spanning Tree Enable
802.11 Mode 802.11b/g/n
Channel Number 6
SSID Wireless
Broadcast SSID Enable
HT Protect Disable
Data Rate Auto
Output Power 100% (Full)
Channel Mode 20MHz
WMM Enabled
RTS Threshold (byte) 2346
Fragmentation Length (byte) 2346
Beacon Interval 100
DTIM Interval 1
Space in Meter 0
Flow Control by AP Disable
Security Open System