Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 47)

Operator's Manual
DISPLAY - INTENSITY, INTS
The INTenSity command sets the intensity level of the grid and trace.
Command Syntax
INTenSity GRID,<value>[PCT],TRACE,<value>[PCT]
Query Syntax
INTenSity?
Response Format
INTenSity TRACE,<value>,GRID,<value>
Example
The following example sets the grid intensity to 60% and trace intensity to 90%.
INTS GRID,60,TRACE,90
DISPLAY - PERSIST, PERS
The PERSIST command enables or disables the persistence display mode.
Command Syntax
PERSist <mode>
<mode>:= {ON, OFF}
Query Syntax
PERSist?
Response Format
PERSist <mode>
Example
The following instruction turns the persistence display ON:
PERS ON
Related Commands
PERSIST_SETUP
920836 Rev B 45