Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 48)

WaveAce Remote Control
DISPLAY - PERSIST_SETUP, PESU
The PERSIST_SETUP command sets the duration of the display, in seconds, when in persistence mode.
The persistence can be set on all traces or per trace.
The PERSIST_SETUP? query indicates the current status of the persistence.
Command Syntax
PErsist_SetUp <time>
<time>:= {1, 2, 5, infinite}
NOTE: The <mode> argument Top2 used by some older instruments is not supported.
Query Syntax
PErsist_SetUp?
Response Format
PErsist_SetUp <time>
Example
The following instruction sets the variable persistence to 10 seconds on all traces:
PESU 20
Related Commands
PERSIST
46 920836 Rev B