Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 102)

WaveRunner 6 Zi and 12-Bit HRO
94 922136-00 Rev A
Touch-and-Drag Zooming
1. Touch and drag a rectangle around any part of an input channel
waveform, math trace, or memory trace. The Zoom (Z1 to Z4) dialog
opens.
Note : If you have enclosed a combination of channel and math or memory traces
in the rectangle, a pop-up Rectangle Zoom Wizard is shown. Touch a Zoom
button (Z1 to Z4).
2. Turn off the zoom traces by touching the Undo button at the top-
right corner of the screen.
OR
Uncheck the Trace On checkbox in the dialog for each zoom trace.
Quickly Zooming Waveforms
Quickly create a Zoom trace by either pressing the front panel Zoom button
or touching the Zoom button on the respective channel dialog.
Turning Off Zoom
Turn off a Zoom by either pressing the front panel Zoom button again.
OR
On the corresponding Zoom dialog, touch the Trace On checkbox to
remove the check mark and disable the zoom trace.