Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 132)

WaveRunner 6 Zi and 12-Bit HRO
124 922136-00 Rev A
Mask Testing
Users may load or create a pixel-based mask on the display grid using a
variety of methods. Test conditions can be set, and a pass/fail result
returned based on whether the condition was found to be true or false.
The source of the mask is always a trace (Channel, Zoom, Math waveform).
Creating a Mask
1. After selecting Analysis → Pass/Fail, the Pass/Fail dialog is shown.

If you touch the Q1 button, a pop-up is shown where you can select
the Mask test Pass Fail Condition.
Now, the Q1 dialog is shown and shows the Mask test condition
selected.

If you touch the Q1 tab, the Q1 dialog is shown. Touching the
Condition control shows the same pop-up where you can select the
Mask test Pass Fail Condition.