Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 96)

WaveRunner 6 Zi and 12-Bit HRO
88 922136-00 Rev A
Persistence Setup
Touch Display → Persistence Setup... on the menu bar.
Now, touch the Persistence On checkbox and refer to the following
scenarios based on your needs.
Persistence Setup for All Input Channels at Once
1. Touch the All Locked button.
2. Touch one of the Mode buttons.
3. Touch the Show last trace checkbox if you want the last trace
displayed.
4. Touch inside the Saturation data entry control and provide a whole
number integer.
For more information on saturation, see the Saturation Level topic.
5. Touch inside the Persistence time data entry control and make a
selection from the pop-up menu.
Persistence Setup for Each Input Channel Individually
1. Touch the Per Trace button.
2. Touch one of the persistence mode buttons next to an input
channel.
To turn off persistence for an individual channel, touch the left-most
persistence mode button next to the channel.
OR