Measure modes, Standard vertical parameters, Standard horizontal parameters – Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual User Manual
Page 109: Selecting measure modes
Getting Started Manual
922136-00 Rev A
101
B
Measure Modes
The selections for Measure Mode allow you to quickly apply parameters for
standard vertical and standard horizontal setups, and custom setups.
Standard Vertical Parameters
These are the default Standard Vertical Parameters:
Vertical
mean
sdev
max.
min.
ampl
pkpk
top
base
Standard Horizontal Parameters
These are the default Standard Horizontal Parameters:
Horizontal
freq
period
width
rise fall
delay
duty
num points
Selecting Measure Modes
1. Touch Measure → Measure Setup... on the menu bar.
2. Under Measure Mode, select the Std Vertical or Std Horizontal
buttons.
Note
: You can customize parameters by touching
My Measure
. Learn
more in the Customize a Parameter topic (available in the online help files).
3. Touch inside the Source data entry control and choose a source for
which the measurements should apply.