Teledyne LeCroy CANbus TD and CANbus TDM - Operators Manual - Manual (Page 20)

CANbus Trigger, Decode, and Measure
20
CANbus-TD-TDM-OM-E RevB
2. For a specific measurement parameter, touch the parameter icon or parameter name to
access the CAN Measurement Select pop-up dialog.
3. From the CAN Select Measurement window, choose a parameter. Touch an icon to select
the measurement.
4. Touch the source field to open the Select Source pop-up dialog. Select a category to
display the available sources, then select the appropriate source.
Note:The source for the CAN measurements should be Decode1, Decode2, Decode3 or
Decode4 depending on which serial data decode is being used to decode the bus you
are trying to measure.
5. The View and Load Table checkbox is checked automatically when you select your
parameters. Uncheck it to turn measurements OFF.
Note: Measurement parameter and source selections that are set up in the CAN
Measure menu are copied to the oscilloscope standard Measure menu.