Teledyne LeCroy CANbus TD and CANbus TDM - Operators Manual - Manual (Page 49)

Operator's Manual
CANbus-TD-TDM-OM-E RevB
49
triggered CAN message.

sets the horizontal settings to real-time sample
mode using 4 channels.

if connected to a channel, it also resets various
channel settings (interpolation, variable gain, scale
and offset, averaging, etc.) to a default value.
Qty. 1: USB2.0 Cable -- Provides power to the Trigger
Module. Also downloads CAN trigger conditions from the
oscilloscope’s CAN Trigger dialog to the Trigger Module.
Qty. 2: 120

Terminations -- A 9-pin to 9-pin DSUB
connector with an internal 120

termination between pins
2 and 7 (to convert a low-speed cable to a high-speed
cable).
Qty. 1: CAN Bus Connection Cable (High-speed)