Alpine IVA-D310 - Manual (Page 37)

35
-EN
01GB05IVA310.fm
ALPINE IVA-D310 68-02278Z28-A (EN)
Make sure “OPTICAL OUT” is ON in “Setting the Digital Output”
(page 35) before switching this setting.
Setting item: A.PROC TYPE
Setting contents: PXA-H510 / OTHER
• After input selection is completed, turn ignition OFF and back ON
again. Your setting of the optical digital input switch is completed.
To connect an audio processor using the optical digital output, set to
“ON” by the following procedure.
Setting item: OPTICAL OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The setting
of Digital Output is decided.
Display Setup Operation
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [OTHER SETUP].
The OTHER SETUP screen appears.
3
Touch [ ] of DISPLAY SETUP.
The DISPLAY setup screen appears.
4
Touch [ ], [ ] or [OFF], [ON], etc., of the desired
item to change its setting.
Setting items:
DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO
BACKGROUND / FONT TYPE / BASE COLOR / PULSETOUCH /
SCREEN ALIGNMENT
5
Touch [RETURN] to return to the previous screen.
Touch [CONTROL] to return to the main source screen that
was displayed before the setup operation was started.
• Immediately after changing the settings of Display Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF.
Otherwise, the settings may not be changed.
Backlighting is provided by a fluorescent light built into the liquid
crystal panel. The illumination control adjusts the brightness of the
backlighting based on the car ambient lighting for easier viewing.
Setting item: DIMMER
Setting content: OFF / ON / AUTO
• When ON or AUTO is set, the setting is also applied for the button
lighting in “Adjusting the Dimmer of Button Lighting at Night”
(page 32).
Optical Digital Input Selection for an
External Audio Processor
OTHER: When connecting any audio processor via an
optical digital cable except the PXA-H510.
Connect the optical digital input connector with the
connector for the Head unit.
PXA-H510: When connecting PXA-H510.
Connect the optical digital input connector with the
connector for the DVD.
Setting the Digital Output
DISPLAY Setup
To display the Display mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Display mode operation has been
released. Engaging the parking brake can reactivate the Display
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To display the Display mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the Display mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of DISPLAY Setup. Refer to each section for
details.
Setting the Brightness of the Backlighting
OFF: Deactivate Auto Dimmer mode to keep the background
illumination of the monitor bright.
ON: Keep the background illumination of the monitor dark.
AUTO: Adjust the brightness of the background illumination of
the monitor automatically to the brightness of the car
interior.
01GB00IVAD310.book Page 35 Wednesday, December 1, 2004 4:20 AM