2 clear cmos jumper, Figure 4-6: at power select jumper location, Figure 4-6 – IEI Integration KINO-GM45A User Manual
Page 64
KINO-GM45A Mini-ITX SBC
Page 52
Figure 4-6: AT Power Select Jumper Location
4.5.2 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type:
3-pin header (1x3)
Jumper Settings:
See
5
Table 4-3
Jumper Location:
See
5
Figure 4-7
If the KINO-GM45A fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
5
Table 4-3.