IEI Integration KINO-GM45A - Manual (Page 98)

KINO-GM45A Mini-ITX SBC
Page 86
Î
COM2 System is remotely accessed through COM2
Î
COM3 System is remotely accessed through COM3
Î
COM4 System is remotely accessed through COM4
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Î Base Address, IRQ [3E8h, A]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Î Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
ƒ 115200 8,n,1 D EFAULT
ƒ 57600 8,n,1
ƒ 38400 8,n,1
ƒ 19200 8,n,1
ƒ 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Î Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Î
Disabled The console is not redirected after POST