IEI Integration KINO-945GSE2 - Manual (Page 73)

KINO-945GSE2 Motherboard
Page 61
NOTE:
IEI has a wide range of backplanes available. Please contact your
KINO-945GSE2 vendor, reseller or an IEI sales representative at
2
[email protected] or visit the IEI website (
2
http://www.ieiworld.com.tw )
to find out more about the available chassis.
4.6.2 Motherboard Installation
To install the KINO-945GSE2 motherboard into the chassis please refer to the reference
material that came with the chassis.
4.7 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.7.1 Audio Kit Installation
The Audio Kit that came with the KINO-945GSE2 connects to the audio connector on the
KINO-945GSE2. The audio kit consists of three audio jacks. Mic-in connects to a
microphone. Line-in provides a stereo line-level input to connect to the output of an audio
device. Line-out, a stereo line-level output, connects to two amplified speakers. To install
the audio kit, please refer to the steps below:
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-10.