IEI Integration KINO-HM551 - Manual (Page 62)

KINO-HM551
Page 48
Before the KINO-HM551 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-HM551 are listed in
6
Table 4-1.
Description Type Label
AT/ATX power select 3-pin header J_ATXCTL1
Clear CMOS 3-pin header J_CMOS1
ME RTC Register 3-pin header ME_RTC1
LVDS voltage selection 3-pin header J_VLVDS1
LVDS panel resolution
selection
8-pin header J_PID1
Serial Port Mode setting 8-pin header JP2, JP3
Table 4-1: Jumpers
4.5.1 AT/ATX Power Select Jumper Settings
Jumper Label: J_ATXCTL1
Jumper Type: 3-pin header
Jumper Settings: See
6
Table 4-2
Jumper Location: See
6
Figure 4-6
The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX.
AT/ATX Power Select jumper settings are shown in
6
Table 4-2.
AT Power Select Description
Short 1 - 2 Use ATX power Default
Short 2 - 3 Use AT power
Table 4-2: AT/ATX Power Select Jumper Settings
The location of the AT/ATX Power Select jumper is shown in
6
Figure 4-6 below.