IEI Integration KINO-HM551 - Manual (Page 69)

KINO-HM551
Page 55
Figure 4-12: Dual RS-232 Cable Installation
Secure the bracket. The dual RS-232 connector has two D-sub 9 male connectors
secured on a bracket. To secure the bracket to the chassis please refer to the reference
material that came with the chassis.
4.7.2 SATA Drive Connection
The KINO-HM551 is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 7: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 8: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector.