IEI Integration IMBA-XQ354 v1.10 - Manual (Page 105)

IMBA-XQ354 Motherboard
Page 85
Figure 5-13: Single RS-232 Cable Installation
Step 3: Secure the bracket. The single RS-232 connector has one D-sub 9 male
connector secured to a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassis Step 0:
5.5.5 SATA Drive Connection
The IMBA-XQ354 is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See
9
Figure 5-14.