IEI Integration IMBA-XQ354 v1.10 - Manual (Page 113)

IMBA-XQ354 Motherboard
Page 93
Figure 5-20: Parallel Device Connector
Step 3: Secure the connector. Secure the DB-25 connector to the external interface by
tightening the two retention screws on either side of the connector. Step 0:
5.6.4 Serial Device
The IMBA-XQ354 has a single female DB-9 connector on the external peripheral interface
panel for a serial device. Follow the steps below to connect a serial device to the
IMBA-XQ354.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
9
Figure 5-21.