4 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration IMBA-C604EP User Manual
Page 73: Eripheral, Evice, Onnections, Figure 4-9: usb power selection jumper locations
Advertising
IMBA-C604EP ATX Server Board
Page 57
Figure 4-9: USB Power Selection Jumper Locations
4.4 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.4.1 SATA Drive Connection
The IMBA-C604EP is shipped with four SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-10.
Advertising