IEI Integration NANO-945GSE v2.00 - Manual (Page 75)

NANO-945GSE EPIC Motherboard
Page 75
Figure 4-2: CF Card Installation
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper. Figure 4-3: Jumper Locations
Before the NANO-945GSE is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the NANO-945GSE are listed
in
7
Table 4-1.