IEI Integration NANO-945GSE2 - Manual (Page 73)

NANO-945GSE2
Page 59
Step 1: Align the connectors. Make sure that the connectors are lined up correctly.
The connectors should match up with the slot of the same shape.
Step 2: Push straight down until the card is properly seated. Push the card straight
downwards to connect. Use a firm pushing action to connect. When the cards
are connected properly there will be no gaps between the baseboard connectors
and the card connectors. Step 0:
4.7.3 SATA Drive Connection
The NANO-945GSE2 is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See
7
Figure 4-12.