IEI Integration NANO-945GSE2 - Manual (Page 83)

NANO-945GSE2
Page 69
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
7
Figure 4-21.
Figure 4-21: Serial Device Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
4.8.4 USB Connection (Dual Connector)
The external USB connectors provide easier and quicker access to external USB devices.
Follow the steps below to connect USB devices to the NANO-945GSE2.
Step 1: Locate the USB connectors. The location of the USB connectors is shown in
Chapter 3.
Step 2: Insert a USB plug. Insert the USB plug of a device into the USB receptacle on
the external peripheral interface. See
7
Figure 4-22. Step 0: