5 usb cable (dual port without bracket), Figure 4-14: single rs-232 cable installation – IEI Integration NANO-945GSE2 User Manual
Page 76
NANO-945GSE2
Page 62
Figure 4-14: Single RS-232 Cable Installation
Step 4:
Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Step 5:
Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.
Step 0:
4.7.5 USB Cable (Dual Port without Bracket)
The NANO-945GSE2 is shipped with a dual port USB 2.0 cable. To connect the USB
cable connector, please follow the steps below.
Step 1:
Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2:
Align the connectors. The cable has two connectors. Correctly align pin 1on