IEI Integration NANO-9453 v1.10 - Manual (Page 123)

NANO-9453 EPIC Motherboard
Page 103
Figure 5-20: Four Serial Port Connector Cable Connection
Step 4: Attach DB-9 serial port connectors to the chassis. The four DB-9 serial port
connectors can be inserted into four preformed holes in the chassis. Once,
inserted the DB-9 connectors should be secured to the chassis with the
retention screws. Step 0:
5.6.7 USB Cable (Dual Port)
The NANO-9453 is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 1: Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the NANO-9453 USB connector.