IEI Integration NOVA-945GSE v1.01 - Manual (Page 91)

NOVA-945GSE 5.25” SBC
Page 91
Figure 5-2: CF Card Installation
5.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper. Figure 5-3: Jumper Locations
Before the NOVA-945GSE is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the NOVA-945GSE are listed
in
829H780H
Table 5-1.