IEI Integration PM-LX-800 v1.10 - Manual (Page 91)

Page 91
PM-LX-800 CPU Card
Boot Up Floppy Seek [Disabled]
Use the Boot Up Floppy Seek option to enable the BIOS to determine if the floppy disk
drive installed has 40 or 80 tracks during the POST. 360K FDDs have 40 tracks while
760K, 1.2M and 1.44M FDDs all have 80 tracks.
Disabled (Default) BIOS does not search for the type of FDD drive by track
number. Note that there is no warning message if the
drive installed is 360K.
Enabled BIOS searches for a FDD to determine if it has 40 or 80
tracks. Note that BIOS cannot tell the difference between
720K, 1.2M or 1.44M drives as they all have 80 tracks.
Boot Up Numlock Status [On]
Use the Boot Up Numlock Status option to specify the default state of the numeric
keypad.
Off The keys on the keypad are not activated.
On (Default) Activates the keys on the keypad.
Gate A20 Option [Fast]
Use the Gate A20 Option option to set if the keyboard controller or the chipset controls
the Gate A20 switching.
Normal The keyboard controller does the switching.
Fast (Default) The chipset does the switching.
Typematic Rate Setting [Disabled]
Use the Typematic Rate Setting configuration option to specify if only one character is
allowed to appear on the screen if a key is continuously held down. When this option is
enabled, the BIOS reports as before, but it then waits a moment, and, if the key is still held