4 single rs-232 cable (without bracket), Figure 4-8: single rs-232 cable installation – IEI Integration PM-LX2-800 User Manual
Page 64
PM-LX2-800 User Manual
Page 64
4.8.4 Single RS-232 Cable (without Bracket)
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1:
Locate the connector. The location of the RS-232 connector is shown in
Step 2:
Insert the cable connector. Insert the connector into the serial port box header.
See Figure 4-8. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-8: Single RS-232 Cable Installation
Step 3:
Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Step 4:
Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, connect a serial communications device to the chassis or
bracket.