IEI Integration WAFER-945GSE2 v2.00 - Manual (Page 66)

WAFER-945GSE2 3.5" Motherboard
Page 51
Figure 4-8: SATA Power Cable Connection
The SATA power cable can be bought from IEI. See Optional Items in Section 2.4.
4.6.2 Dual RS-232 Cable Connection (w/o bracket) (Optional)
The dual RS-232 cable consists of two connectors attached to two independent cables.
Each cable is then attached to a D-sub 9-pin male connector. To install the dual RS-232
cable, please follow the steps below.
Step 1: Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 4-9. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.