IEI Integration ECW-281B_D2550 - Manual (Page 32)

ECW-281B-D2550 Embedded System
Page 18
Step 1: Remove the bottom surface. See Section
765
3.2 .
Step 2: Remove the hard drive bracket from the bottom surface by removing the four
retention screws that secure the bracket to the bottom surface. (
765
Figure 3-3 )
Figure 3-3: HDD Bracket Retention Screws
Step 3: Place the HDD into the bracket.
Step 4: Align the retention screw holes in the HDD with those in the bottom of the
bracket.
Step 5: Secure the HDD with the bracket by inserting four retention screws into the
bottom of the bracket (
765
Figure 3-4 ).
Figure 3-4: HDD Retention Screws