Figure 3-5: hdd thermal pad – IEI Integration ECW-281B_D2550 User Manual
Page 33
ECW-281B-D2550 Embedded System
Page 19
Step 6:
Locate the breather hole of the HDD. Cut off the corresponding area of the
breather hole from the thermal pad.
Step 7:
Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
765
Figure 3-5
).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the
breather hole may cause damage to the HDD.
Figure 3-5: HDD Thermal Pad
Step 8:
Replace the HDD bracket onto the bottom surface by aligning the four retention
screw holes in the HDD bracket with those in the back of the bottom surface.
Step 9:
Reinsert the four previously removed retention screws.
Step 10:
Connect the supplied SATA and power cable to the ECW-281B-D2550 and
HDD.
Step 11:
Replace the bottom surface to the bottom panel by reinserting the ten previously
removed retention screws.
Step 0: