IEI Integration ECW-281B_D2550 - Manual (Page 40)

ECW-281B-D2550 Embedded System
Page 26
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 3-3.
Clear CMOS Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 3-3: Clear CMOS Jumper Settings
The clear CMOS jumper location is shown in
5
Figure 3-15 below.
Figure 3-15: Clear CMOS Jumper Location