IEI Integration ECW-281B_B2-D525 - Manual (Page 48)

ECW-281B/B2-D525 Embedded System
Page 35
4.2.4.2 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See
765
Table 4-3
Jumper Location: See
765
Figure 4-3
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
765
Table 4-3.
CF Card Setup Description
OFF Slave Default
Short 1-2 Master
Table 4-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in
765
Figure 4-3.
Figure 4-3: CF Card Setup Jumper Location
4.2.4.3 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See
7765
Table 4-4
Jumper Location: See
7765
Figure 4-4