IEI Integration ECW-281B_B2-D525 - Manual (Page 53)

ECW-281B/B2-D525 Embedded System
Page 40
Step 4: Align the retention screw holes in the HDD with those in the bottom of the
bracket.
Step 5: Secure the HDD with the bracket by inserting four retention screws into the
bottom of the bracket (
765
Figure 4-9 ).
Figure 4-9: HDD Retention Screws
Step 6: Locate the breather hole of the HDD. Cut off the corresponding area of the
breather hole from the thermal pad.
Step 7: Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
765
Figure 4-10 ).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the breather
hole may cause damage to the HDD.