IEI Integration uIBX-200 v1.10 - Manual (Page 35)

UIBX-200-R11/Z510P Embedded System
Page 25
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
Pin Description Pin Description
1 DCD 6 DSR
2 RX 7 RTS
3 TX 8 CTS
4 DTR 9 RI
5 GND
Table 4-6: Serial Port Pinouts
Figure 4-12: Serial Port Pinouts
4.5.5 USB Connector
CN Label: USB
CN Type: USB port
CN Location: See Figure 4-5 and Figure 4–6
CN Pinouts:
See Table 4-7
The USB ports are for attaching USB peripheral devices to the system.
Step 1: Located the USB connectors . The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors. See Figure 4-13.