Figure 3-6: wall-mounting bracket – IEI Integration TANK-101B-D525_N455 v1.00 User Manual
Page 28
TANK-101B/BW Em b e d d e d S ys te m
P a g e 18
S te p 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
Figure 3-6: Wall-mounting Bracket
S te p 6:
Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the bottom panel of the system and tighten until the screw
shank is secured against the bottom panel (Figure 3-7).
S te p 7:
Align the mounting screws on the TANK-101B/BW bottom panel with the
mounting holes on the bracket.
S te p 8:
Carefully insert the screws through the holes and gently pull the monitor
downwards until the TANK-101B/BW rests securely in the slotted holes (
3-7). Ensure that all four of the mounting screws fit snuggly into their respective
slotted holes.
NOTE:
In the diagram below the bracket is already installed on the wall.