IEI Integration ECN-680A-H61 - Manual (Page 35)

ECN-680A-H61 Em b e d d e d S ys te m
P a g e 21
Figure 3-9: Close the CPU Socket
S te p 12: Install the fan module in the same position it was before and tighten the eight fan
bracket retention screws. See Section 3.3.
S te p 13: Connect the fan connector (CPU_FAN1). See Section 3.3.
S te p 14: Replace the cover and secure it using five previously removed retention screws.
See Section 3.3.
3.5 Ha rd Dis k Drive (HDD) In s ta lla tio n
To install the hard drive, please follow the steps below:
S te p 1: Remove four (4) retention screws from the HDD cover, two from the bottom
panel and two from the right side, as shown in
335H
Figure 3-10.