IEI Integration ECN-680A-H61 - Manual (Page 46)

ECN-680A-H61 Em b e d d e d S ys te m
P a g e 32
3.11.2 DVI Dis p la y De vic e Co n n e c tio n
The ECN-680A-H61 has one female DVI-I connector and one female DVI-D connector on
the rear panel. The DVI connectors are connected to digital display devices. To connect a
digital display device to the ECN-680A-H61, please follow the instructions below.
S te p 1: Locate the DVI connector. The location of the DVI connector is shown in
Chapter 1.
S te p 2: Align the DVI connector. Align the male DVI connector on the digital display
device cable with the female DVI connector on the external peripheral interface.
S te p 3: Insert the DVI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the ECN-680A-H61. See
359H
Figure 3-23.
Figure 3-23: DVI Connector
S te p 4: Secure the connector. Secure the DVI connector from the digital display device
to the external interface by tightening the two retention screws on either side of
the connector.