IEI Integration ECN-680A-H61 - Manual (Page 42)

ECN-680A-H61 Em b e d d e d S ys te m
P a g e 28
3.10.1 Mo u n tin g th e S ys te m with Mo u n tin g Bra c ke ts
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
S te p 1: Turn the embedded system over.
S te p 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface.
S te p 3: Secure the brackets to the system by inserting two retention screws into each
bracket as illustrated in
340H
Figure 3-19.
Figure 3-19: Mounting Bracket Retention Screws
S te p 4: Drill holes in the intended installation surface.
S te p 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.