IEI Integration AFL-W19A_17D_W15A-N270 v3.00 - Manual (Page 30)

AFL-W19A/17D/W15A-N270 Panel PC
Page 19
Closed Master
Table 2-4: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in Figure 2-8.
Figure 2-8: CF Card Setup Jumper Location
2.5.4 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type:
3-pin header
Jumper Settings: See Table 2-5
Jumper Location: See Figure 2-9
If the AFL-W19A/17D/W15A-N270 fails to boot due to improper BIOS settings, the clear
CMOS jumper clears the CMOS data and resets the system BIOS information. To do this,
use the jumper cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ Enter the correct CMOS setting
ƒ Load Optimal Defaults
ƒ Load Failsafe Defaults.