Figure 2-21: wall-mounting bracket – IEI Integration AFL-W19A_17D_W15A-N270 v3.00 User Manual
Page 42
AFL-W19A/17D/W15A-N270 Panel PC
Page 31
Step 3:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 2-21).
Figure 2-21: Wall-mounting Bracket
Step 6:
Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the real panel of the flat panel PC and tighten until the screw
shank is secured against the rear panel (Figure 2-22).
Step 7:
Align the mounting screws on the monitor rear panel with the mounting holes on
the bracket.
Step 8:
Carefully insert the screws through the holes and gently pull the monitor
downwards until the monitor rests securely in the slotted holes (Figure 2-22).
Ensure that all four of the mounting screws fit snuggly into their respective
slotted holes.