Figure 2-18: wall arm – IEI Integration AFL-W19A_17D_W15A-N270 v3.00 User Manual
Page 40
Advertising
AFL-W19A/17D/W15A-N270 Panel PC
Page 29
Figure 2-18: Wall Arm
To install the AFL-W19A/17D/W15A-N270 on the arm, follow the directions below.
NOTE:
Make sure the arm supports standard VESA mounting. The
AFL-W19A/17D/W15A-N270 uses a VESA mounting to attach to the
arm.
Step 1:
The arm is purchased separately. Follow the instructions in the arm's user
manual to securely attach the arm to the wall.
Step 2:
Once the mounting arm has been firmly attached to the surface, lift the flat panel
PC onto the interface pad of the mounting arm.
Step 3:
Align the retention screw holes on the mounting arm interface with those in the
flat panel PC. The arm mount retention screw holes are shown in Figure 2-19.
Advertising