Figure 2-27: afl-w15a-n270 cutout – IEI Integration AFL-W19A_17D_W15A-N270 v3.00 User Manual
Page 47
Advertising
AFL-W19A/17D/W15A-N270 Panel PC
Page 36
large enough for the rear panel of the flat panel PC to fit through. Recommended
cutout size shown below.
Figure 2-27: AFL-W15A-N270 Cutout
Step 3:
Slide the flat panel PC through the hole until the aluminum frame is flush against
the panel.
Step 4:
Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame.
Step 5:
Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel.
S
te
p
0
:
Advertising