Figure 7-4: ddr so-dimm module installation – IEI Integration AFL2-15A-H61 User Manual
Page 138
AFL2-15A-H61
Page 121
Step 1:
Follow all anti-static procedures. See Section 7.2.
Step 2:
Turn off the power. See Section 7.3.
Step 3:
Remove the back cover. See Section 7.4.1 above.
Step 4:
Remove the internal aluminum back cover. See Section 7.4.2 above.
Step 5:
Locate the DDR3 SO-DIMM on the motherboard.
Step 6:
Remove the DDR3 memory module by pulling both the spring retainer clips
outward from the socket.
Step 7:
Grasp the DDR3 memory module by the edges and carefully pull it out of the
socket.
Step 8:
Install the new DDR3 memory module by pushing it into the socket at an angle
(Figure 7-4).
Step 9:
Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (Figure 7-4).
Step 10:
Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 7-4: DDR SO-DIMM Module Installation
Step 11:
Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.