IEI Integration AFL2-15A-H61 - Manual (Page 38)

AFL2-15A-H61
Page 21
ƒ Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the flat bezel panel PC.
Step 2: Install the HDD.
Step 3: Install the CF card.
Step 4: Install the RFID reader. (optional)
Step 5: Configure the system.
Step 6: Connect peripheral devices to the flat bezel panel PC.
Step 7: Mount the flat bezel panel PC. Step 0:
3.4 HDD Installation
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AFL2-15A-H61, please follow the steps below:
Step 1: Remove two (2) retention screws from the HDD cover (Figure 3-1).