IEI Integration AFL2-W15A-N270_W15A-L325 v1.01 - Manual (Page 8)

AFL2-W15A-N270/L325 Panel PC
Page viii
List of Figures
Figure 1-1: AFL2-W15A-N270/L325 ...............................................................................................2
Figure 1-2: Front Panel ..................................................................................................................4
Figure 1-3: Rear Panel....................................................................................................................5
Figure 1-4: AFL2-W15A-N270 Bottom Panel................................................................................6
Figure 1-5: AFL2-W15A-L325 Bottom Panel ................................................................................6
Figure 1–6: Dimensions .................................................................................................................9
Figure 2-1: Plastic Back Cover Retention Screws ....................................................................14
Figure 2-2: HDD/CF Card Brackets (shown with all plastic covers removed)........................14
Figure 2–3: HDD Installation (shown with all covers removed)...............................................15
Figure 2–4: CompactFlash® Slot Location (shown with all covers removed) .......................16
Figure 2–5: CompactFlash® Install (shown with all covers removed)....................................17
Figure 2-6: Plastic Back Cover Retention Screws ....................................................................18
Figure 2-7: Expansion module installation (shown with all covers removed) .......................19
Figure 2-8: USB Dongle Installation ...........................................................................................22
Figure 2-9: CF Card Setup Jumper Location .............................................................................25
Figure 2-10: Clear CMOS Jumper ...............................................................................................27
Figure 2-11: COM1 Pin 9 Setting Jumper Locations.................................................................28
Figure 2-12: COM3 Pin 9 Setting Jumper Locations.................................................................30
Figure 2-13: COM3 RX Function Select Jumper Location........................................................31
Figure 2-14: COM3 RS-232/422/485 Serial Port Select Jumper Location................................33
Figure 2-15: COM3 TX Function Select Jumper Pinout Locations..........................................35
Figure 2-16: Arm Mount Retention Screw Holes .......................................................................37
Figure 2-17: Arm Mounting (ARM-11-RS)...................................................................................38
Figure 2-18: Cutout.......................................................................................................................39
Figure 2-19: Tighten the Panel Mounting Clamp Screws .........................................................40
Figure 2-20: Stand Mounting (Stand-A19)..................................................................................41
Figure 2-21: Wall Mount ...............................................................................................................41
Figure 2-22: Wall-mounting Bracket ...........................................................................................42
Figure 2-23: Chassis Support Screws ........................................................................................43
Figure 2-24: Secure the Panel PC ...............................................................................................44