IEI Integration AFL2-08A-N26 - Manual (Page 153)

AFL2-08A-N26
P a g e 137
5. Create factory default image (see Section C.2.5)
After completing the five initial setup procedures as described above, users can access
the recovery tool by pressing <F3> while booting up the system. The detailed information
of each function is described in Section C.5.
NOTE:
The initial setup procedures for Linux system are described in
Section C.3.
C.1.1 S ys te m Re q u ire m e n t
NOTE:
The recovery CD can only be used with IEI products. The software will
fail to run and a warning message will appear when used on non-IEI
hardware.
To create the system backup, the main storage device must be split into two partitions
(three partitions for Linux). The first partition will be for the operating system, while the
second partition will be invisible to the operating system and contain the backup made by
the one key recovery software.