IEI Integration AFL2-08A-N26 - Manual (Page 39)

AFL2-08A-N26
P a g e 23
 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear and anti-static wristband.
4.3 In s ta lla tio n a n d Co n fig u ra tio n S te ps
The following installation steps must be followed.
S te p 1: Unpack the flat bezel panel PC.
S te p 2: Install the mSATA card.
S te p 3: Configure the system.
S te p 4: Connect peripheral devices to the flat bezel panel PC.
S te p 5: Mount the flat bezel panel PC. S te p 0:
4.4 m S ATA c a rd In s ta lla tio n
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the mSATA card into the AFL2-08A-N26, please follow the steps below:
S te p 1: Remove one (1) retention screw from the mSATA cover (Figure 4-1).