IEI Integration AFL2-08A-N26 - Manual (Page 55)

AFL2-08A-N26
P a g e 39
S te p 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See Figure 4-18.
Figure 4-18: DB-9 Serial Port Connector
S te p 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
S tep 0:
4.12.4.2 RJ -11 S e ria l P o rt Co n n e c tio n
Follow the steps below to connect a serial device to the RJ-11 serial port connector of the
AFL2-08A-N26 panel PC.
S te p 1: Locate the RJ-11 serial port. The location of the RJ-11 serial port is shown in
Chapter 1.
S te p 2: Connect the RJ-11 to DB-9 COM port cable to the panel PC. Insert the RJ-11
connector end of cable into the RJ-11 serial port. See Figure 4-19.
S te p 3: Connect the serial device. Connect a serial device to the DB-9 connector end
of the cable. See Figure 4-19.