Lincoln Electric IM10136 VRTEX MOBILE - Manual (Page 18)

A-11 INSTALLATION
VRTEX ® MOBILE
A-11
BREAkDOWN PROCEDURE
1.Makecertaintheinputpowerswitchontherearof
the machine is on the “Off” position.  See Figure
A.14.
2.Disconnect the input power cord from the back of
themachine.
3.Disconnecttheremainingcablesintheclusterfrom
themonitor.
4.DisconnectUSBandaudiojackontheaudiovisual
(A/V)cableclusterfromthespeakers.
5.Securetheunigunattachment(s)andweldcoupons
intotheleftsideaccesspanel.SeeFigureA.15.
6.Removeriserarmassemblyfromthecouponriser
stand by removing the two pins securing the two
piecestogether.SeeFigureA.16.
7.Remove the coupon riser stand from the coupon
riser base by pressing down on the release tab
locatedonthebaseandslidingoffthestand.See
FigureA.16.Couponriserstandandbasecannow
besetasideforrepackaging.
8.Disconnect and repackage the following cables
fromtherearofthemachine:
•RiserArmCable
•AudioVisual(A/V)CableCluster
•MachineInputLineCable
9.Carefully place components into the component
compartmentontherightsideofthemachine.See
Right Side Component Compartment Diagram
(Figure A.10).
NOTE: Original packing materials, such as foam
and plastic bag, are recommended if
machine is to be relocated.
Do NOT ship monitor without its packag-
ing foam.
FIGURE A.14 – INPUT POWER SWITCH
INPUT
POWER
SWITCH
ELECTRIC SHOCk can kill.
•Only qualified personnel should
perform this installation.
• Turn the input power OFF and
unplug the machine from the recep-
tacle before working on this equip-
ment.
• Always connect the VRTEX ® MOBILE to a power
supply grounded according to the National
Electrical Code and local codes.
------------------------------------------------------------
WARNING
FIGURE A.15 – UNIGUN, COUPON
AND ATTACHMENTS
LEFT SIDE
ACCESS PANEL
MACHINE
FRONT
VR SMAW ADAPTER
(OPTIONAL) K3165-3
FIGURE A.16 – COUPON RISER
STAND AND BASE
RISER ARM
ASSEMBLY
COUPON
RISER
STAND
COUPON
RISER
BASE
PINS (2)
CAUTION
CAUTION